With open hand spray gun turn device
on and off multiple times with the device
switch.
Note: By dismantling the spray lance from
the hand spray gun, the venting process is
accelerated.
Interrupting operation
Release the lever of the trigger gun; the
device will switch off.
Pull again the lever of the trigger gun;
the device will switch on again.
Select spray type
Close the hand spray gun.
Use the safety catch to secure the
handgun lever.
Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using de-
tergents or cleaning at low
pressure.
High pressure flat spray (25°)
for large dirt areas
Operation with detergent
– For considerate treatment of the envi-
ronment use detergent economically.
– The detergent must be suitable for the
surface to be cleaned.
Illustration
Take out detergent suck hose.
Turn filter on the detergent suction hose
in order to dispense the detergent.
Suspend end of suction hose in a con-
tainer filled with detergent.
Set nozzle to "CHEM".
22
Set the detergent concentration accord-
ing to the surface to be cleaned.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Recommended cleaning method
– Loosen the dirt:
Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
– Remove the dirt:
Spray off loosened dirt with the high
pressure jet.
Operating with cold water
Removal of light contaminations and clear
rinse, i.e.: Gardening tools, terrace, tools,
etc.
Set the appliance switch to "1".
Operating with hot water
DANGER
Scalding danger!
Set the appliance switch to "2".
After operation with detergent
Completely close the filter at the deter-
gent suction hose (-).
Set the appliance switch to "1".
Open the hand spray gun and rinse the
appliance for at least 1 minute.
Turn off the appliance
DANGER
Danger of scalding by hot water. After oper-
ation with hot water, the device must be op-
erated with open end handgun with cold
water for at least two minutes.
Set the appliance switch to "0/OFF".
Shut off water supply.
Turn on pump shortly (appr. 5 seconds)
with device switch.
Set the appliance switch to "0/OFF".
Activate hand spray gun until device is
pressure less.
– 6
EN
Cleaning