Inserting / Replacing Batteries; Operation - Silvercrest IAN 282123 Originalbetriebsanleitung

Inserting / replacing batteries

Q 
 
S et the speed control
the batteries.
 
S lide the battery cover
 
I nsert two 1.5 V AA batteries in the battery compartment
Please note the polarity (+ and -). This is shown in the battery
compartment
 
S lide the battery cover
until you hear it lock in place.
11

Operation

 
S et the speed control
or removing an attachment.
 
U se light pressure to install the desired attachment onto the
shaft
9
 
S et the speed control
the product along with the LED
CAUTION! Always begin with the lowest speed and only
increase the speed if necessary.
Now begin using the product.
 
S et the speed control
product off.
 
R emove the attachment from the shaft
unit when finished or to use a different attachment.
7
Note: If the performance of the product decreases, the bat-
teries are drained. Promptly replace these with the same type
batteries.
14 GB
8
12
.
11
12
8
of the hand-held unit
8
8
to the „0" position before inserting
down.
back onto the battery compartment
to the „0" position before installing
.
7
to the „I" or „II" position to switch on
.
10
to the „0" position to switch the
9
11
of the hand-held
.