Setting The Clock; Heating Or Cooling Programs - Bpt TH 125 Gebrauchsanweisung

18
24
15
22
6
18
After approximately 10 s, or if you press the
button, the display will show the time
P
and room temperature again.
Note. When reset button R is pressed, the
temperature differential returns to the ±0.2
°C default setting.

5 - SETTING THE CLOCK

5.1 - Press the button (fig. 15).
The minutes digits flash.
5.2 - Press the button or
until the correct minutes value is reached.
Each time the or button is pressed,
the digits on the display go up by one. When
you hold this button down, the digits on the
display increase slowly for the first 5 s then
the sequence of digits advances more quickly.
5.3 - Press button (fig.17).
The hour digits flash.
10
20
26
22
P
28
24
R
Fig. 14
(fig. 16) 5.4 - Press the button
until the correct hour is reached.
5.5 - Press the button
ting procedure (fig. 19).
The colon between the hours and minutes
flashes to confirm the operation is complete.
In any case, if no button is pressed for 10 s,
the unit automatically exits this procedure,
saving the last data set.
18
24
15
P
22
R
6
18
Fig. 15
20
26
18
24
22
15
22 28
6 24
18
Fig. 16
6 - HEATING OR COOLING
or (fig. 18),
PROGRAMS
to end the set- Press the button (
the cooling (
The corresponding indication will come on.
In the cooling program, the temperature can
be set from 18 °C to 31 °C.
Over 31 °C, the system goes into shutdown
mode, which is indicated by the message
18
24
15
22
6
18
Fig. 17
20
26
18
24
22
15
22 28
6 24
18
Fig. 18
) (fig. 20) to choose
) or heating ( ) program.