Усунення Несправностей - Ugears Star Wars R2-D2 Aufbauanleitung

ENG
Troubleshooting
Issue Possible causes and troubleshooting
1. The LED does not 1. Ensure the LED is intact and undamaged.
light up during The battery* must not be depleted.
testing (p. 4)
2. Connect the LED terminals to the correct battery polarity: the longer
leg is «+» (positive), the shorter is «–» (negative).
3. If the LED still does not light up, check that the battery is new and
undamaged, and confirm that the «+» and «–» terminals are not re-
versed.
1. While operating in the mechanism, assist the motion manually using
2. Model mechanism
does not operate (p. 13) the helper tool by gently pushing the pendulum modules and gears
without applying force (see p. 13).
2. Carefully disassemble the model and verify that all modules are as-
sembled according to the manual. Ensure that all parts are fully inser-
ted and lubricated with para n.
1. Make sure the ON/OFF switch is installed as shown in the manual and
3. The LED does not
fully set to the ON position (p. 35).
light up (p. 35)
2. Check that the LED contacts are bent correctly according to the
instructions (p. 33).
3. The «+» contact may not be fully touching the battery*. Try gently
pushing it closer to the ON/OFF switch using the helper tool, ensuring
better contact (p. 33).
4. Verify that the battery is functional and correctly installed. Confirm
that the polarity matches the wiring diagram (p.35).
UKR
Усунення несправностей
Проблема Можливі причини та способи усунення
1. 1.
( . 4).
2.
"–".
3.
1.
2.
( )
(
( . 13)
2.
1.
3. C
( . 35).
2.
3.
4.
( . 35).
,
* .
: – "+",
, ,
, «+» «–»
,
. 13).
,
.
, « / »
«
,
( . 33).
«+»
« / »
* ( . 33).
.
,
.
–
.
,
,
» ( . 35).
,
*,
,
,
,