Philips RC369 Bedienungsanleitung Seite 8

RADIO
3
2
WAVEBAND
• Briefly press the BAND
desired waveband.
FMI, FM2, or FM3,
(when the Choice
'RADIO' option; see INITIAL SETTINGS).
FMI, FM2, or FM3,
(when the Choice
'AMERICA' or 'ASIA'
see INITIAL SETTINGS).
SEARCH TUNING
Use search tuning to quickly search for a station.
• Briefly press the <
— You will receive a station
To search for another station,
again.
USEFUL TIPS
You can suppress MW or LW bands if not in
used,
• see INITIAL SETTINGS; select Option
or 'LW' and set the Choice
Cannot tune to desired
• Desired station _istoo weak, try Manual
Tuning.
• See INITIAL SETTINGS; check option
'RADIO.
• see INITIAL SETTINGS;
and set the Choice to 'DX'
MANUAL TUNING (if you know the frequency
of the required station)
• Press the MANUAL key for at least 2 seconds
(until you hear a beep) to switch from search
tuning to manual tuning.
• Tune to the desired frequency
key (keeping the key pressed
frequency quickly)
= higher frequency
= lower frequency
Note: The radio automatically
to search tuning after about 50 seconds with
a beep.
8
4
5
6
key to select
The display shows:
MWI, or MW2, or LW
is set to 'EUROPE' under
AMI, or AM2
is set to 'LATAM'
under 'RADIO' option;
key or key .
after a short time.
press the key
to •OFF',
station?
select
with < and
changes
switches
PRESET KEYS 1-6 (STORE
Six stations per waveband
recalled using the preset keys (1 to 6).
Storing a station
• Briefly press the BAND
desired waveband.
• Tune-in the desired station frequency.
• Press the desired preset key (1 to 6) for at least
the
2 seconds (until you hear a beep).
Note: A
automatically
stored on the preset.
Recalling a station
• Briefly press the desired preset key.
The display will show the band, frequency and
or
preset number.
AUTO STORE
You can automatically
FM3 band or
AM2(MW2) band by using AUTOSTORE
function. When you use Auto
station replace
the FM3 band
Automatically
• Briefly press the BAND key to select the desired
waveband.
— Briefly press the AST key, you will hear a beep.
The set mutes and display shows iFM3 AST'
or 'MW2 ASTI
— You will hear a beep when
storing 6 stations.
— You will hear the station on preset 1.
Sometimes
stations. In this case, the remaining
are programmed
stations are found,
stations are maintained.
FREQUENCY
The scan function
of all the stations
current waveband.
for about 10 seconds.
• Press SCAN key for at least 2 seconds
the
switch SCAN
back
AND PRESET)
can be stored and
key to select the
previously-stored
erased if a new frequency
(AST)
store 6 FM stations
6 AM(MW) stations
Store, the new
any station previously
or the AM2 (MW2) band.
storing stations
or 'AM2 ASTI.
it has finished
it may not be possible to find six
with 0000 (radio mute).
the previously
SCAN
gives you a quick impression
which can be received
You hear each station
function on or off.
station is
is
on
on the
(AST)
stored in
presets
If no
stored
on the
in turn
to