Philips RC369 Bedienungsanleitung Seite 4

AERIAL
Fix antenna adaptor * (EA6257/OO) if needed.
Insert aerial plug into aerial
reception is only possible with a good aerial).
(Optional) Secure the aerial wire with cable tie.
CONNECTOR C *
• CD changer (fig.3) : You can connect (see
mounting instructions for the CD changer) the
following CD changer (D2Btype) to this set:
- RC032
- RC026/OO
- RC026/50, order new cable EA6263
• Portable player (fig.4) : You can connect
portable DCC, CD or cassette player to this set
(instead of a CD changer) to this set. Use the
cable (EA6786) mentioned
The cable must be connected
750mV (in most cases the headphone
of the portable player is suitable).
Refer to INITIAL
ISRCI and set the Choice
— This indicates to the set that a portable player
is connected instead
— Increase the volume of the portable
desired level.
CONNECTOR D
• Philips Remote Control EA2001 (fig.2) : You
can connect a Philips remote control (EA2001)
to this set (see mounting
EA2001).
REAR STUD
Screw rubber buffer E onto fixing stud at rear of
set.
4
EA6257/OO
socket (good
in the illustration.
to an output
output
SETTINGS, select Option
to 'AUX'.
of a CD changer.
player to
instructions for the
MOUNTING
METAL SLEEVE (fig.5)
• Install the metal sleeve (dimension
in the dashboard.
• Fix metal sleeve into place by pressing the metal
tags outwards using a screwdriver.
MOUNTING RADIO
This radio can be properly installed either from
conventional Front Mounting or Rear Mounting.
FRONT MOUNTING
• Slide the radio into the metal sleeve
springs at either side of the radio snap into
the openings
• Finally reconnect the negative car battery
terminal (fig.7).
REMOVING RADIO (using the two U- brackets
supplied)
• Insert both U-brackets
front of the set until they lock. Pull out the radio
(Fig.8).
REAR MOUNTING
• Remove the trimplate
a
and the side springs.
• Selecta position where the screw holes of the
mounting bracket and the screw holes of the
radio become aligned and tighten the screws
of
at 2 places on each side.
• Only use M5 screws that are not longer than
6mm.
REPLACING FUSE (Fig. 2)
• Use a IOA blade-type
182x53 mm)
of the sleeve (fig.6).
into the holes
(fig.9)
around the front panel
fuse.
until the
on the