Philips RC369 Bedienungsanleitung Seite 3

INSTALLATION
If your car is equipped
simply insert them in connectors of the car radio.
If not, you can use an adaptor
the table on the separate installation
PREPARATION
Voltage and polarity: The set must be connected
to a 12V car battery with negative terminal to
earth (car chassis).
Warning: To prevent short-circuiting,
the negative car battery terminal
has been mounted and connected (fig. 1). See
separate installation card.
CONNECTOR A (fig.2)
Recommended Power supply connections
• Red lead A7 : Connect
supply (switched on/off by car ignition).
• Yellow/red lead A4 : Connect to a permanent
12V supply.
• Brown lead A8: Connect to earth (car chassis).
Alternative Power supply connections
ON/OFF LOGIC (see illustration
installation card for correct
• Red lead A7 : Connect to a permanent
supply.
• Yellow/red lead A4 : Connect
12V supply (switched on/off by car ignition).
• Brown lead A8: Connect to earth (car chassis).
• See INITIAL SETTINGS; select Option 'LOGI'
and set the Choice
— The ON/OFF LOGIC feature
set (for one hour) after you have removed the
car ignition key.
— The ON/OFF LOGIC
functions only if your car has been prepared
for it (e.g. certain VW and Opel/Vauxhall cars).
Consult your car service manual or check with
your dealer to confirm
* only for certain versions
with ISO connectors,
cable (Refer to
card).
disconnect
until the set
to a switched
for
on separate
connection).
to a switched
to 'ON'.
enables use of the
feature in this
this.
OTHERS CONNECTIONS (fig.2)
Pink lead wire (Telephone mute) : If your car
telephone provides a mute signal, it can be
used to automatically
audio output.
— Connect the telephone
wire (TEL. MUTE).
See INITIAL SETTINGS; select Option IPHONE'
and set the Choice to ILO' or 'HI' according
phone type.
Blue lead A5 (Automatic
can provide a 12V signal for the control of an
automatic motor
electronic aerial by connection.
Do not use this connection for the supply lead
of the aerial
Orange lead A6: Connect to a 12V supply.
•
When the car headlamps
knobs of radio are illuminated
12 V
radio is switched
Line-output
•
You can connect a power amplifier
4* additional
RCA cable.
— Connect Red socket to Right channel
white socket
— Connect Blue wire to Amplifier Remote on/off.
CONNECTOR B (fig.2)
12V
Loudspeakers (use 4 ohm loudspeakers only)
• Do not connect any of the loudspeaker
to earth or directly to a booster/amplifier.
• Connecting
Front
Green [B5]
Left-
Green/black
Right+ Grey [831
set
Right- Grey/black
interrupt
mute wire to Pink lead
Aerial) : This radio
aerial or the supply
motor!
are switched on, the
(even when the
off).
*
loudspeaker) to this set with the
to Left channel.
4 loudspeakers
Rear
White
[B6]
White/black
Blue [BII
[B4]
Blue/black
the sets's
to
of an
(with 2 or
and
leads
[B7]
[88]
3