Philips RC369 Bedienungsanleitung Seite 7

AUDIO ADJUSTMENT
SOUND
2
1
SCAN
i
SOURCE BAND
• POWER : Press Power key to switch the set
on or off.
• VOLUME : Press —key or + key to adjust the
volume.
Please make sure you can still hear the traffic
(horns, sirens........)
• SOUND : Choose one ofthe predefined
styles with the SOUND
BASS-TRE : Your own settings
treble.
FLAT : Mid-positions
- JAZZ: Jazz music
VOCAL : Speech
CLASSIC : Classic music
ROCK Rock music
• SELECT : Choose the desired
SELECT key.
BASS (low notes),
BALANCE (left-right),
— Press - key or + key to adjust the selected
audio mode. Adjustment
Loudness settings
'BASS-TRE' is selected as the sound style.
Note: After 5 seconds the display goes back
to the last mode of operation.
• LOUD : To reinforce
when listening at a low volume
the LOUD key at least 2 seconds (until you hear
a beep) to switch ioudness on or off.
• MUTE: Press the MUTE key for at least 2
seconds to mute the sound
Press any key to restore the same volume
ievel.
Note: The silent period may be interrupted
traffic announcements
switched on).
• SOURCE : Briefly press the SOURCE key to
select the desired source. The display
RADIO, TAPE or CHANGER
* only for certain versions
BORS
3
sound
key.
of bass and
of bass and treble
audio mode with
TREBLE (high notes),
FADER (rear-front).
of Bass, Treble and
only applicable when
bass and treble especially
level. Press
momentarily.
(if TA/NEWS
shows:
* (AUX
SETTING THE CLOCK
Press INIT key for at least 2 seconds (until you
•
hear a beep) to enter the Initialisation mode.
— Display shows 'INIT'.
Press < or
Press AST key to select 1121-1' or '24H'.
•
Press key :
•
— Display shows e.g. '00:00' (24 hour fomat) or
'AM 12:00' (12 hour
— Hour digit start flashing.
Press AST key to adjust Hour digit.
•
Press key again :
•
— Minute digit start flashing.
Press AST key to adjust Minute digit.
Press INIT key for at least 2 seconds (until your
hear a beep) to leave the Initialisation
10 seconds after any key operations, the display
will always shows
activated.
USEFUL TIPS
You can change the colour of the displaw
• see INITIAL
'COLOUR' andset the Choice to iGX(Green)
or TO' ( Orange)}
Set functions but no sound?
e Adjust the volume of theset,
• Adjust Fader Settings.
Set mutes when you drive or display shows
'TEL CALL'.
• See VINITIAL SETTINGS;
'PHONE/ and set the Choice to 10'
according to phone type pr
is connected,
Set muteswhenyou used the telephone,
display shows 'TELCALL% but you may stilli
-like to listen to the radio.
• Briefly press + KEY to restore the same
volume level.
by
Display shows 'TOO HOTi and the sound from
is
the speakers is reduced,
• A bulit-in safety circuiQprevents the
temperature
certain *level,
Wait until. 'TOO HOT' disappearS from the
display before increasing the volume.
*
key to select option 'TIME'.
format).
mode.
time when clock
SETTINGS; select
select Option
if no phone
in the set from exceeding
mode is
-Option
Or' OHIO
a
7