Replacing The Decorative Door Panel; Fitting Up And Removing The Handle; Fitting Up The Handle; Removing The Handle - Dometic miniCool DS 200 Bedienungsanleitung

GB
10. Replacing the decorative
door panel
If the refrigerator is furnished with handle, it is the
handle that should be first removed at the change of
the door panel.
Remove the mounter screws (1) of the forehead panel
(3).
Remove rosette (2) (in case of with lock version
fridge).
Lift and remove the forehead panel.(3)
Slide the decorative panel (4) out of the door frame
and insert the new panel (thickness max. 2 mm).
Place back the forehead panel,rosette and screw in
reverse sequence.
11. Fitting up and removing the
handle
The handle which can be found among the
accessories of the appliance should be fitted and
removed as follows:

12. Customer service

Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does not cool sufficiently
The appliance does not cool at all and the
LEDs are flashing
The appliance does not cool at all and
there is no lighting at all
When checking all the above points and the
refrigerator is still not working satisfactorily, contact
your nearest service engineer. State the problem,
model, product- and serial-number.
8
(Fig. 11.)
1
3
1
4
Figure 11.
Thermostat control is set too low.
Too much food to be cooled was put in.
Door is not shut properly.
Internal air circulation is restricted.
CUC system stopped the operation.
Plug is not connected to the mains socket properly
There is no voltage in the mains socket.

11.1. Fitting up the handle

2

11.2. Removing the handle

Possible cause
(Details of the model, product- and serialnumber
are to be found on the data label in the top left of
the inside compartment.)
In the event of a fault developing, contact your nearest
Service Centre-see local telephone directory.
(fig. 12., 13.)
Figure 12.
Figure 13.
(fig. 14.)
Figure 14.
Solution
Set to a higher position.
Put in less food to be be cooled.
Check if the door is shut.
Provide inside cool air circulation.
See operating instruction 5.3.
Check if the connection is proper.
Check if there is voltage.