Cleaning; Positioning The Appliance; Installation Instruction; Built-In Versions - Dometic miniCool DS 200 Bedienungsanleitung

11
2. Door
3. Evaporator
4. Thermostat knob
5. Cooling unit cover
6. Interior light
IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC ZRT DO NOT ACCEPT
LIABILITY FOR LOSS OR DAMAGE OF KEYS. HOWEVER A COMPLETE LOCK CAN BE SUPPLIED.

3. Cleaning

Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these parts, as
well as the cabinet interior and the door should be
washed with a warm solution of sodium bi-carbonate.
Finally wipe over with a cloth rinsed in warm water
only, and dry with a clean cloth. Do not wash any
plastic parts in water that is more than hand warm, and
do not expose them to dry heat. The outside of the
cabinet should be wiped down regularly with a clean,
damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE
CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
DS 400
1. Door lock (if available)
11
Figure 2.
7. Shelves
8. Footframe
9. Air-sensor
10. Door racks
11. Evaporator-sensor
During the refrigeration process, the
appliance gives off heat from the condenser
(under the upper part of the rear cover) into the
surrounding air. The more ventilated the condenser
is, the more effective the refrigeration will be.
The other condition for satisfactory operation is
that the appliance is levelled. This could be
checked by placing a glass of water on top of the
appliance.
It is important that the appliance is not directly
exposed to radiated heat (sunlight, radiator, near
an oven, etc.).
Please do not place the refrigerator onto thick
carpet!
4.1. Installation instructions
All four sizes of the miniCool family are available in
built-in and freestanding version.

4.1.1. Built-in versions

This version is intended for built in purposes. Built
in models do not have foot frames, cooling unit
covers compared to the freestanding versions
(figure 1).
DS 600
GB
5