Installing The Batteries Into The Transmitter - HobbyZone Mini Super Cub Bedienungsanleitung

EN

Installing the Batteries into the Transmitter

1. Remove the transmitter back cover.
2. Install the included AA batteries. Use four fresh 1.5V
AA batteries only.
3. Be sure to observe proper polarity when installing the
batteries, and then replace the cover.
8
4. To test, switch on the transmitter. The LED should glow
brightly.
5. Replace the batteries when you hear the low battery
alarm (beeping sound).
Note: You may notice a small switch immediately below
the LED and the power switch. This small switch deter-
mines the "mode" that the transmitter operates on. The
default position is the switch to the left (Mode 2). Moving
the switch position to the right allows the transmitter to
operate on Mode 1.