HobbyZone Mini Super Cub Bedienungsanleitung Seite 14

EN
4. Push the elevator stick full forward. When this is done,
the elevator should move down (as shown), causing
the plane to pitch down.
6. If your airplane is not responding, DO NOT flY IT.
Some correction is needed. Please refer to the
troubleshooting section at the end of this manual. If
further assistance is still needed, please contact the
appropriate Horizon Hobby Service Center.
7. When you are satisfied your airplane is set up properly,
you can unplug the flight battery and then turn off the
transmitter. This should be done every time you have
finished flying.
14
5. Pull back on the elevator stick. When this is done,
Down
NOTE: It is very important to make sure that the control
surfaces (rudder and elevator) are at 0º when the rudder
and elevator sticks are also centered (at neutral).
Ideally, they will be at 0º when the transmitter is
powered on.
the elevator should move up (as shown), causing the
plane to pitch up.
UP