VEVOR RBC-25 Bedienungsanleitung Seite 22

Store carefully
When not in use, store cutter and accessories in dry place where they can't
be accessed by unauthorized person.
Operating Instructions
Caution: Indicates hazard that could result in minor personal injury and/or
product damage.
Care: Indicates hazard that will result in product damage.
Pre-use checks
1.Check oil level.
2.Check condition of cutter blocks and tightness of cutter block bolts.
Caution: Using loose or cracked cutter blocks may result in injury to
operators as well as damage to unit.
3.Check that the power source is appropriate for the cutter.
4.Care : If voltage is too high , the motor will burn out. If the voltage is too
low, insufficient power will be generated. Never use DC current.
5.Check that power supply is properly earthed.
6. Caution: Failure to earth power supply may result in electric shock to
operator.
7.Check that cord is undamaged and that plug is not loose.
Caution: Cut or abraded covering could result in a short and electric shock
to operator.
Warm-up
In cold weather , warm up unit for 30-60 seconds so that the hydraulic oil
reaches the proper viscosity. Pull trigger -switch to extend piston and
release when it has reached its full stroke, Repeat 15-20 times.
Stopper adjustment
The adjustable stopper function to maintain the rebar in the correct position
during cutting and must be properly set for each size of rebar before
- 21 -