Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
RF Exposure Information(if applicable)
•DO NOT operate the radio without a proper antenna attached, as this may damage the radio and
may also cause you to exceed RF exposure limits. A proper antenna is the antenna supplied with this
radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this
radio, and the antenna gain shall not exceed the specified gain by the manufacturer declared.
•DO NOT transmit for more than 50% of total radio use time, more than 50% of the time can cause RF
exposure compliance requirements to be exceeded.
•During transmissions, your radio generates RF energy that can possibly cause interference with other
devices or systems. To avoid such interference, turn off the radio in areas where signs are posted to
do so.
•DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as
hospitals, aircraft, and blasting sites.
•Portable Device, this transmitter may operate with the antenna(s) documented in this filing in
Push-to-Talk and body-worn configurations. RF exposure compliance is limited to the specific belt-clip
and accessory configurations as documented in this filing and the separation distance between user
and the device or its antenna shall be at least 2.5 cm.
•Mobile Device, during operation, the separation distance between user and the antenna subjects to
actual regulations, this separation distance will ensure that there is sufficient distance from a properly
installed externally-mounted antenna to satisfy the RF exposure requirements.
•Occupational/Controlled Radio, this radio is designed for and classified as "Occupational/Controlled
Use Only", meaning it must be used only during the course of employment by individuals aware of the
hazards, and the ways to minimize such hazards; NOT intended for use in a General population/un-
controlled environment.
•General population/uncontrolled Radio, this radio is designed for and classified as "General
population/uncontrolled Use".
RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the occupational/controlled environment
exposure limits, always adhere to the following procedures.
Guidelines:
•User awareness instructions should accompany the device when transferred to other users.
•Do not use this device if the operational requirements described herein are not met.
Operating Instructions (if applicable):
•Transmit no more than the rated duty factor of 50% of the time. To Transmit (Talk), push the Push to
Talk (PTT) button. To receive calls (listen), release the PTT button. Transmitting 50% of the time, or
less, is important because the radio generates measurable RF energy exposure only when
transmitting in terms of measuring for standards compliance.
•Transmit only when people outside the vehicle are at least the recommended minimum lateral
distance away from a properly installed according to installation instructions, externally mounted
antenna.
•When operating in front of the face, worn on the body, always place the radio in a Retevis approved
clip, holder, holster, case, or body harness for this product. Using approved body-worn accessories is
important because the use of Non-Retevis approved accessories may result in exposure levels, which
exceed the IEEE/ICNIRP RF exposure limits.
7