Start Guide; Battery Meter - Retevis Ra17 Bedienungsanleitung

Installation the battery
1. Make sure your radio is turned OFF.
2. Remove the battery compartment door.
3. Install the 4 NiMH rechargeable battery or 4 AAA Alkaline batteries into the battery
compartment.
4. Replace the battery compartment door.
Basic radio operations
1. Press to turn on
2. Press MENU to enter the channel settings, the channel display pattern starts flashing,with ▲/▼
to select. Press PTT to confirm and exit.
3. Press MENU twice to enter the setting. OFF for no code, 01-38 for CTCSS code.39-99 for DCS
code
4. Press MENU for 3 times to enter the Vox function selection. there are OFF,1,2.3 these 3 gea
sensitivity optional
5. Press MENU for 4 times to enter the CALL tone selection function. Thev are 01 to 10 sounds
available
6. Press MENU for 5 times to enter the key tone selection function, select the button when the ON
button will beep a tone, select the OFF button when there is no tone.
7. Press MENU for 6 times to enter the launch end of the tone selection function, with to select.
select ON to release the PTT will have a tone, the opposite choice of OFF there is no tone.
8. Press MENU for 7 times and exit can also press PTT to confirm the exit menu
Note
It doesn't has charaing function, it can't be charged directly through charger base and so on, it
only can be charged by a NiMH vrechargeable battery.
When installing the battery, please pay attention to the corresponding positive and negative
placement!

Battery METER

indicates that battery is fully
indicates that battery is LOW
The LCD appears
Tunning your Radio ON/OFF
1. To turn your radio ON ,press and hold (
2. To turn your radio OFF.press and houd (
Adjusting the Volume
1. press the ▲ button to increase the speaker volume
2. press the button to decrease the speaker volume.
3. The speaker volume level is indicated on the LCD

Start Guide

.
icon please replace batteries immediately
) button 3 seconds
) button 3 second again.
displayed(1-8 Level).
2