Sony SU-P50T1 Gebrauchsanweisung Seite 5

Step 1: Check the parts
• Prepare a Phillips screwdriver beforehand.
• Exercise extreme care to avoid injury when installing the Main Bracket.
Main Bracket (1 piece)
Step 2: Install the Main Bracket
1
Align the Main Bracket over the screw holes on the stand. Then fasten
the Main Bracket to the stand using 10 countersink screws.
Be sure that two or more persons hold the parts during this procedure.
Tighten the 10 countersink screws once again after screwing them temporarily.
Caution
• Be sure to hold the stand firmly and keep it stable.
• When you use an electric driver to tighten screws,
tightening torque must be approx. 2.45 N·m. Do
not use impact drivers.
If you use impact drivers or electric drivers with
the tightening torque other than 2.45 N·m, you will
overtighten the screws. This may destroy parts or
screws, cause the Main Bracket to drop off from the
stand, leading to any injury.
Stand (1 piece)
Main Bracket
Countersink
screws
For Sony Dealers
Name Quantity
Securing screw
Countersink screw
Cable clamper
For Sony Dealers
Stand
2
10
1
5
(GB)