Setting Up The Faytech Touch Software - Faytech 0700 SI/BL Bedienungsanleitung

Setting up the faytech Touch software

Start the administration program by going to "Start - Programs -TouchKit –
Configure Utility". (If you accepted all the defaults the program may be at "Start –
Programs – Accessories – Touchkit – Configure Utility".) Or you can find this
program in the system tray section of your task bar.
tab
1.General
Gives information on whether one or more touch controllers are found and
installed.
After the initial installation, if no touch controller shows up on this tab, please
pull out the USB connector on your PC and connect the device again.
tab
2. Setting
When you touch the touch panel there is a beep if you select the first checkbox.
You can change the frequency and duration of the beep. The changes will be
saved after you click on "OK".
Under , you can choose the number of linearization points under
linearization
the . On a 25-point linearization the deviation of a
Tools - linearization setting
touched point will be less than on a 9-point linearization. In general, the faytech
displays have been set correctly and should not be linearized.
. You can set how fast you need to click on the same object
Double Click Time
to make a double click. If you choose
you choose , then you can tap the screen more slowly..
>> Longer
The same applies to
Double Click Area
must be in a relatively small area in order for a double click to be recognized.
enables you to make a successful double- click within a larger area.
Larger
, then you need to tap faster. If
Shorter <<
. If you choose , your taps
Smaller <<
44 faytech Ltd. 2009
C
Setting up the faytech Touch software
To the right of the mouse icon are options to set different mouse-like modes.
Normal mode offers the most intuitive touch-operation.
Normal-Mode
touch pen or a finger. This is the best mode to use for most applications.
Click on touch
initiate a new mouse-click, the display must be released and re-pressed.
Click on release
click when the display is released.
Click on touch without moving cursor
click. The cursor follows the finger / pen movement.
understanding of this setting, try it with the
tab.
Tools
>>
Click on release without moving cursor
touch position except at the lift-off point. For a better understanding of this
: Allows the user to select an object or drag an object with the
: The "click" is recognized when the screen is touched. To
: Contrary to the click
function in touch
: The first touch point generates a
Draw Test
: The cursor does not move to the
45
, it is generated a
For a better
application under the