Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting up the faytech Touch software
to indicate time elapsed. If the touch screen is not touched before the progress
bar gets to the far right, the calibration task will be terminated automatically.
The
button will clear all calibration and linearization settings. It
Clear and Calibrate
will then automatically take you through a 4 Points Calibration.
The
( 25 or 9 points calibration ) function is used to compensate the
Linearization
touch screen linearity. It will require you to press and hold on 9 or 25 targets on the
screen so it can compensate for the curvature (if any) of the display.
linearization is completed, the linearity of the touch screen will be shown in the
Linearity curve window.
The
function is used for accuracy and performance checking. Press this
Draw Test
button and a new pop up window will be popped up on the monitor (see below).
Touch or drag your touch pen or finger on this grid to gauge the effectiveness of the
settings and calibrations that you have made. If you are using your finger, you may
have to press firmly to draw continuous lines. Press the Clear button to clear the
window. Press the Quit button to terminate this draw test.
Display-Multi-Monitor
tab:
4.
Setting
If you selected "Support Multi-Monitor System" when you installed the Touch
driver, you will see a Display tab when you run the Touchkit Configure utility. If
you did not select this option, you will not see a Display tab.
You can have up to four faytech touch-screens connected simultaneously. You
quit
48
faytech Ltd. 2009
C
Setting up the faytech Touch software
can also use a (non-touch) display and a touch screen. In the example below,
the touch-screen is display "1", while the second display "2" is a normal monitor.
Both have the same resolution, but the touch screen is the primary monitor.
After
Enable multiple-monitors
will be mapped to the primary monitor automatically. When this function is
enabled, you can double click on the monitor area in the monitor geometry
window to assign the monitor area where the touch screen will be mapped.
Double-tap on the desired monitor and answer the question in the pop-up
window with
After confirmation, your touches on the selected touch monitor will be
simulated as mouse clicks.
If the function "
" is activated, the program automatically puts the touch function on the
system
primary monitor, if only one monitor is connected.
The
Operation mode
your faytech touch-screen. E.g. if you select the "right screen", after a new
calibration only the right side of the monitor will work as a touch area. If you
select "other" and then click on the ->> button, you can set more modes or set
confirm
: When this function is disabled, the touch screen
.
Yes
The touch sensor is automatically connected to the main
settings allow you to set the size of the touch area on
49
Is the touch- sensor attached to the monitor?
Yes
No
Werbung
Inhaltsverzeichnis
