Setting Up The Faytech Touch Software - Faytech 10 INCH TOUCH MONITOR Bedienungsanleitung

SETTING UP THE FAYTECH TOUCH SOFTWARE

Start the administration program by going to "Start - Programs -TouchKit – Configure Utility". (If
you accepted all the defaults the program may be at "Start – Programs – Accessories –
Touchkit – Configure Utility".) Or you can find this program in the system tray section of your
task bar.
1. General tab
Gives information on whether one or more touch controllers are found and installed.
After the initial installation, if no touch controller shows up on this tab, please pull out the USB
connector on your PC and connect the device again.
2. Setting tab
When you touch the touch panel there is a beep if you select the first checkbox. You can
change the frequency and duration of the beep. The changes will be saved after you click on
"OK".
Under linearization, you can choose the number of linearization points under the Tools -
linearization setting. On a 25-point linearization the deviation of a touched point will be less
than on a 9-point linearization. In general, the faytech displays have been set correctly and
should not be linearized.
Double Click Time. You can set how fast you need to click on the same object to make a
double click. If you choose Shorter <<, then you need to tap faster. If you choose >> Longer,
then you can tap the screen more slowly..
The same applies to Double Click Area. If you choose Smaller <<, your taps must be in a
relatively small area in order for a double click to be recognized. >> Larger enables you to
make a successful double- click within a larger area.
48