Display Connection - Faytech 0700 SI/BL Bedienungsanleitung

Components:
01 Speakers
02 Infrared receiver
03 MODE: switch from VGA to AV1 to AV2. Make sure the input source is
correct or you will not see any image on your screen
04 MUTE: turn speakers on or off
05 VOL-: reduce the volume –or- navigate in the OSD menu –or- change the
highlighted values in the menu
06 MENU: open the OSD menu –or- confirm selection in the OSD menu
07 VOL+: increase the volume –or- navigate in the OSD menu –or- change
the highlighted values in the menu
08 BRIGHTNESS: change the brightness of the display
09 PWR: turn the display on or off
10 Earphone out
11 For the internal power supply of the PC: +12V, GND, Reversing light
12 USB connector for the touch function
13 2x Video connectors, 4x Audio connectors
14 VGA connector to PC
15 All-In-One cable with VGA, USB, power, video and audio connections.
Connect to input (29)
16 120 or 220VAC adapter connects to input (26)
17 120 or 220VAC power plug
18 12V adaptor connects to input (26)
19 12V adaptor to cigarette lighter
20 Mounting case
21 Touch pen (only for display with touch function)
22 Remote control for the display
23 Driver CD (only for display with touch function)
24 User's guide
25 Holder for touch pen
26 12V DC power input
27 Extended USB port to PCs; see section 5 of Display Connections
28 Speakers
29 All-In-One cable (15) input
30 Display stand
32 faytech Ltd. 2009
C

Display Connection

Each cable is labeled for easy connection. To operate your faytech display
properly, there must be at least one signal source and a power supply
connected. If you have the optional touch screen and you want to use it, you
also must have the USB port connected to your PC.
To connect the , you have the following options:
1. signal source
On a PC: Connect the VGA cable from the faytech monitor to the VGA output
l
of your PC graphics card. Please select MODE VGA / RGB, so you have an
image on the display.
On a PC: If you have only one DVI output on your PC, please purchase a DVI
l
to VGA adapter and connect the display via VGA to your PC.
To DVD-Player/camera/Video source: Connect one or two video inputs
l
(labeled Video1 or Video2) to a corresponding video source. Please be sure
to switch off the video source before you connect the cables. Switch MODE to
the respective channel input (AV1 or AV2).
In addition, the display has two stereo audio inputs, one for the PC (red and
white RCA connectors, labeled with PC AUDIO-L and PC AUDIO-R) and one
for the two video inputs (sound is carried on both channels), also a white and
red RCA connector, labeled with AUDIO1-L and AUDIO1-R . Audio comes
through the speakers only if there is an image signal. Audio is also available
from the earphone output on the front side of the display. If earphones are
connected, the built-in speakers will not be active.
You can use the display simultaneously with all three video
Tip:
signal sources. Use the MODE button on the display or the
MODE button on the remote control to switch between the
various signal inputs.
2.Connect power using only one of these options (do not try to connect more
than one power source at the same time):
33