Display Connection - Faytech 2200 Bedienungsanleitung

Components:
1. INPUT: switches the input signal sequentially from VGA to DVI to AV1
to AV2. Make sure the input source is correct or you will not see any
image on your screen.
2. VOL-: decrease volume –or- navigate in the OSD menu
3. VOL+: increase volume –or- navigate in the OSD menu
4. CH-: change the highlighted values in the menu
5. CH+: change the highlighted values in the menu
6. MENU: open the OSD menu –or- confirm selection in the OSD menu
7. PWR: turn the display on or off
8. LED power indicator
9. Infrared receiver
10. VGA connector to PC and to display (20)
11. 120 or 220V adaptor. One end connects to input (22), the other end
plugs into a receptacle
12. DVI cable, one end goes to 21
13. Driver CD
14. Touch pen
15. User's guide
16. USB connector
17. 3.5mm earphone out
18. 3.5mm audio in
19. Video/audio cable connector (this is not an S-video connector!)
20. VGA connector
21. DVI connector
22. 12V DC power input
23. USB cable between PC and display (16)
24. Remote control
.
31

Display Connection

Each cable is labeled for easy connection. To operate your faytech display
properly, there must be at least one signal source and a power supply
connected. If you have the optional touch screen and you want to use it, you
also must have the USB port connected to your PC.
To connect the , you have the following options:
1. signal source
On a PC: Connect the VGA or DVI cable from the faytech monitor to the VGA or
l
DVI output of your PC graphics card. Please select INPUT VGA / RGB or DVI,
so you have an image on the display."
To DVD-Player/camera/Video source: Connect one or two video inputs (using
l
the Video/audio adaptor cable and/or the DVI cable) to corresponding video
sources. Please be sure to switch off the video source before you connect the
cables. Switch MODE to the respective channel input (DVI, AV1 or AV2).
In addition, the display has two stereo audio inputs, one for the PC (3.5mm
audio in) and one for the two video inputs (sound is carried on both channels),
also a white and red RCA connector, labeled with AUDIO1-L and AUDIO1-R .
Audio comes through the speakers only if there is an image signal. Audio is also
available from the earphone output on the back of the display. If earphones are
connected, the built-in speakers will not be active.
You can use the display simultaneously with all four video
Tip:
signal sources. Use the INPUT button on the display or the
INPUT button on the remote control to switch between the
various signal inputs.
.Connect power using only one of these options (do not try to connect more
2
than one power source at the same time):
You can connect the faytech display with the included 120V/220V plug or the
12V power adapter. Insert one of these power sources into the input (22) which
is labeled +12 VDCIN (found on the back side of the display).
32 faytech Ltd. 2009
C