Lux Tools A-RM-46-24 Set Originalbetriebsanleitung Seite 49

– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (12) and (13):
– Battery inserted: red and green LED
flashing for a few seconds (the battery is
self-checking)
– Green control light flashes = Battery pack
is charging.
– Green control light lights = Battery pack is
fully charged.
– Red control light lights = rechargeable
battery not properly inserted in the charg-
ing station
– Red control light flashes = Battery pack is
defective. Do not continue to use the bat-
tery pack!
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
► P. 3, item 3
– Press the button (15).
The remaining capacity of the battery is dis-
played by the control lights on the dis-
play (14):
Preparation
Adjusting the handlebar height
► P. 4, item 4
– Set the handle bar to the required working
height and allow to engage in the drilled
holes (17).
– Press the clamping lever (16) towards the
handlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.
Set the cutting height
The cutting height can be set to several differ-
ent heights (Cutting heights: ► Technical
data – p. 51).
► P. 5, item 8
– Pull the lever (7) to the side.
– Set the cutting height to the value you
require, and let the lever slot back into
place.
Attach the collection box
► P. 5, item 9
– Lift the protective flap (4) and hold.
– Hook in the collection box (8).
– Make that the collection box is securely
engaged.
Mounting the ejection opening
Note: When using the ejection open-
ing, the mulching wedge must be
mounted; the collection container is
not required.
Cut material is distributed on the
grass.
► P. 6, item 10
– Press the unlocking button (29).
– Lift the flap (24).
– Hook on the ejection opening (6).
Mounting the mulch wedge
Note: Mulching is the use of cut grass
as a natural compost. When mulch-
mowing, the grass is cut, finely
chopped and spread across the grass
in one operation.
► P. 6, item 11
– Remove the collecting sack.
– Push the mulch wedge (25) into the open-
ing of the machine until it engages.
– Lower the safety flap (4).
Turning on the tool
Note: The product cannot be
switched on without the circuit
breaker.
► P. 5, item 6
– Insert the circuit breaker (22) (pay atten-
tion to the fit)
► P. 7, item 12
– Press and hold down the switch lock (9).
► P. 7, item 13
– Pull the switch on lever (1) and hold.
– Release the switch lock.
• The unit will switch itself on with approxi-
mately 2 seconds delay.
Operation with two batteries
Note: The device may be operated
using one or two batteries.
– When the device switches itself off auto-
matically, release the switch-on lever.
– To activate the second battery, switch the
device on again.
Switching-off the device
– Release the switch on lever.
GB
49