Your Device At A Glance; Assembly; Operation - Lux Tools A-Rm-46-24 Set Originalbetriebsanleitung

GB
• When maintaining the blades, remember
that even if the machine is switched off,
the blades can still be moved.
• For safety reasons, replace worn or dam-
aged parts. Only use original spare parts
and accessories.
Your device at a glance
Note: The actual appearance of your
product may differ from the illustra-
tions.
► P. 3, item 1
1. Switch-on lever
2. Handlebar
3. Handlebar, bottom part
4. Safety flap
5. Battery cover
6. Ejection opening
7. Lever for adjusting the cutting height
8. Collection box
9. Switch lock
10. Clutch lever for travel drive
Battery charger
► P. 3, item 2
11. Battery charger
12. Control light (green)
13. Control light (red)
Battery pack
► P. 3, item 3
14. Display for remaining capacity
15. Button for remaining capacity
Scope of delivery
• Operating manual
• Lawn-mower
• Handle
• Collection box
• Mulch wedge
• Ejection opening
• Battery charger
• Battery pack
• Circuit breaker
• Bag containing small parts

Assembly

Mounting the handle
Note: All mounting steps must be per-
formed on both sides.
► P. 4, item 4
– Release the clamping lever (16).
48
– Fold the bottom part of the handle bar (3)
over as shown.
– Observe the installation direction:
Lugs (17) must engage as shown.
– There are 3 angle positions when locking
lever screws to the handle (you can see it
in the round plastic parts).
► P. 4, item 5
– Screw the handle (2) using the tensioning
lever screws (18) onto the handle under
section.
– There are 3 angles option in the level lock-
ing base.
– Press the clamping lever towards the han-
dlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.

Operation

Check before starting the device!
DANGER! Risk of injury! The
device may only be put into operation
if there are no defects. If a part is
defective it must be replaced before
the device is used again.
Check to make sure the device is in safe
operating condition:
– Check to make sure there are no visible
defects.
– Check to make sure all device compo-
nents are correctly mounted.
Charging the battery pack
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
unit! Do not allow the battery pack to
deep discharge.
• The battery pack must be charged prior to
the first start-up (charging time: ► Techni-
cal data – p. 51).
– Press in the locking button (21) and
remove the battery from the device
(► P. 5, item 6).
– Insert the battery pack into the
charger (► P. 5, item 7).