Cleaning And Storage - Cleanmaxx 02968 Gebrauchsanleitung

EN
11. The device stops automatically after the set operating time has elapsed. The control
panel goes out and the device switches to stand-by mode.
L
If the operating time should be ended prematurely, press the
process and the
display (13). The control panel goes out and the device switches to stand-by mode.
12. Remove the garment from the balloon and hanger.
13. Pull the mains plug out of the plug socket and allow the device to cool down
completely.
Tips
• If in the pressing programme without steaming hand-washed or non-machine-spun
laundry is to be pressed, allow it to dry first.
• The pressing process without steaming takes around 10 minutes for a spun-dried
shirt. However, the length of time can vary depending on the material and thickness of
the material. We recommend that you start with a shorter time and extend it if neces-
sary.
• The pressing process with steaming takes around 15 minutes for a dry shirt. Here
too the time may vary depending on the material and thickness of the material.
• The balloon for shirts and blouses can be enlarged or reduced in size with the zips.
For smaller sizes, the zips should be closed. For larger sizes, the zips should be opened on
both sides.
• Wide-apart buttons may result in the button strip crimping slightly during pressing.
Here it is advisable to smooth down the button strip again by hand immediately after
the pressing process.

CLEANING AND STORAGE

Please note!
■
Do not use any caustic or abrasive cleaning agents or cleaning pads for cleaning. These
may damage the surface.
• Clean the device and the balloon if necessary with a slightly damp cloth and a little mild
detergent if required. Then wipe with a dry cloth.
• Empty the water tank (5) if the device is not going to be used for a long time or before
storing it away. To do this, remove the balloon and telescopic rod (2) take the device
apart and tilt the motor unit (6) so that the water can escape from the steam outlet
openings beneath the mounting flange (9).
• Allow all parts to dry completely before storing them away.
• Store the device in a clean, dry place which is protected from sunlight and is not
accessible to children and animals.
22
symbol until there is no longer any bar lit up on the operating time
symbol to pause the