DUROFIX RJ1217 Produktinformationen Seite 9

1English1
ASSEMBLY
INSTALLING OR REMOVING BATTERY PACK
B
A
FIG. 2
TO REMOVE BATTERY PACK: Depress the battery release button (see Fig. 2B),
and pull battery pack out of tool.
TO INSTALL BATTERY PACK: Align rails (see Fig 2A), on the tool with the four
tabs on the battery pack, and push battery pack onto tool until it locks in place.
INSTALLING SAW BLADE
1. Turn counter-clockwise and buckle the keyless blade holder (see Fig. 3A).
2. Insert the saw blade into the blade clamp as far as it will go.
3. Loosen the keyless blade holder.
4. Pull saw blade out to make sure it is secured firmly.
REMOVING SAW BLADE
1. Turn counter-clockwise and buckle the keyless blade holder (see Fig. 3A).
2. Take the saw blade out of the blade clamp.
3. Loosen the keyless blade holder.
A
Fig. 3
English
-8