DUROFIX RJ1217 Produktinformationen Seite 10

GLAMPING JAW INSTALLATION AND REMOVAL
NOTE:
Before installing or removing a blade, make sure the switch is fully released and the tool has
stopped turning.
When installing the clamping jaw, snap the clamping jaw into the slot according to
the direction of Figure 4(A); after it is inserted, rotate it into the buckle according to
the direction of Figure 5(B), and fix the whole structure. The final rendering effect is
shown in Figure 6.
Fig. 4
CUTTING OPERATION
1. First, switch on the tool with a slower speed.
2. Press the shoe firmly against the surface.
3. Bring the blade into light contact with the surface.
4. Make a faster speed to continue cutting.
WARNING!!:
During operation, always wear gloves and eye protection to protect your hands and
1English1
A
Fig. 6
OPERATION
English
-9
Fig. 5