Turning Power On - Sharp Multisync Pn-M982 Installationsanweisung
Grossformatbildschirm
Vorschau ausblenden
Andere Handbücher für MultiSync PN-M982:
- Bedienungsanleitung (101 Seiten) ,
- Installationshandbuch (4 Seiten) ,
- Installationshandbuch (4 Seiten)
Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Turning power on
1. Press the POWER button or MONITOR ON button to turn the power ON.
The Main Power switch must be in the ON position in order to power up the monitor using
the POWER button on the remote control unit or on the monitor.
Power LED
lighting pattern
Glowing blue
Blinking green*
2
Glowing amber*
2
(Networked
standby mode)
Blinking amber*
2
(Standby mode)
Glowing red
*
: Time setting for auto power save is available at [POWER SAVE SETTINGS] (See Operation manual page 45).
1
*
: [POWER SAVE] is set to [ENABLE].
2
*
: 90 sec if [INPUT SELECT] is set to [HDMI2] without connecting an HDMI cable to HDMI2 terminal.
3
3 min if [INPUT SELECT] is set to [USB-C].
16
E
Status of the monitor
Normal
Under any of the conditions below, no input signal has been
detected by the monitor during the period of time*
•
An optional sensor unit is not connected to the
REMOTE input terminal or [HUMAN SENSING] is set to
[DISABLE].
•
[INPUT SELECT] is set to [HDMI2] and an HDMI cable
is connected to HDMI2 terminal.
•
[SLOT POWER] is [ON] or [AUTO] then an Option Board
is connected.
•
[AUTO INPUT CHANGE] is set to a setting except for
[NONE].
•
[USB POWER] is set to [ON].
•
[SLOT POWER] is set to [ON].
•
[POWER CONTROL LINK] of [CEC] is set to [ENABLE].
•
[DisplayPort VERSION] is set to [1.2 MST] or [1.4 MST].
•
[QUICK START] is [ENABLE].
•
When 20 sec*
have passed without meeting the
3
conditions of blinking green, when the monitor
recognizes the LAN connection and a certain period of
time has passed without selected signal input.
•
When 3.5 min have passed without the conditions of
blinking amber, when a certain period of time has passed
without the monitor recognizing the LAN connection and
selecting the signal input.
Turn off the monitor by the Remote control unit or the
monitor button.
POWER Button
Recovery
1.
Turn on the
monitor by the
Remote control
you set:
1
unit or the monitor
button.
2. Send an AV
signal input to the
monitor.
Turn on the monitor
by the Remote control
unit or the monitor
button.
Kapitel
Inhaltsverzeichnis
