Charging - Samsung SR8980 Benutzerhandbuch

Charging

When the product is initially purchased, the battery is fully
discharged, and you must charge the vacuum cleaning
robot manually.
1. After aligning the charge pins of the main unit
with the charge pin of the charger station, press
the main unit until you hear a Recharging power
sound from the charger.
- The Charging Lamp turns green.
2. Check the charge status of the vacuum cleaning robot.
- When charging starts, "the amount of remaining battery power"
and "
sequence.
- When charging is complete, the battery level indicator and
"FULL" will be displayed in the display panel.
■
When the battery level display fl ashes while cleaning,
Flash Flash
the vacuum cleaning robot stops vacuuming and
automatically charges itself at the charger.
■
If the vacuum cleaning robot starts the current cleaning
run at a location other than the charging station and fails
to locate the charging station while cleaning, it will stop
near the location where it started cleaning.
Flash Flash
■
When the battery level fl ashes and "Lo" is displayed while
cleaning, vacuum cleaning robot cannot be operated by
the remote control or the buttons on the main unit. In
this case, directly carry the vacuum cleaning robot to the
charger to charge the battery. (This is when the battery is
completely discharged.)
Turn on the Power Switch at the bottom of the product.
" are displayed on the status display panel in this
Power lamp Power lamp
Power lamp Power lamp
Charging lamp Charging lamp
Charging Charging
<Charge display> <Charge display>
Charge Charge
complete complete
Charging lamp Charging lamp
Fully charged Fully charged
Charging Required Charging Required
charging charging
operating _23