Installing The Charging Stand; Installation Guide - Samsung VS20R90 Serie Benutzerhandbuch

Installing the charging stand

Installation guide

2
'Click'
1
3
2
1
3
60 cm 66 cm
❇ ❇ Please refer to the QR code for detailed information on the installation and
charging method of the charging stand.
Assembling the charging stand
1 Assemble the stand pipe to the bottom
support, and fix it with a screw (small).
– Make sure the direction for the
assembly is correct and push it in firmly
so that the screw hole is made correctly.
2 Assemble the vacuum charging part to
the top of the stand pipe.
– Do not disassemble it after the
assembly.
3 Connect the power cord to the rear of the
4
charging stand.
– Hold the connection part of the cord
and push it onto the connection pins
firmly until the gray lines on the tip of
the cord are not visible.
– When inserting the cord into the
groove on the bottom of the bottom
support, charging stand can be installed
close against the wall.
4 Plug in the charging stand.
Fixing by the hook
1 Using the fixing hook as a template, mark
where the top and bottom screw holes
will be placed on the wall.
– Top: 66 cm from the floor
4
– Bottom: 60 cm from the floor
2 Drill the holes using a 6 mm drill bit, and
put the provided screw anchors into the
hole.
3 Fix the fixing hook to the wall with the
provided screws (large).
4 Hook the groove of the charging stand
into the fixing hook.
English 15