Behaviour In Emergency Situations; Residual Risks - Parkside Pdm 600 D2 Originalbetriebsanleitung

People with pacemakers should
consult their doctor before use .
Electromagnetic fields in the vicinity of
the pacemaker can interfere with the
pacemaker or cause the pacemaker
to fail . Furthermore, people with
pacemakers should:
Avoid working alone .
—
Properly maintain and check to avoid
an electric shock .
The warnings, precautionary measures
and instructions described in this
user manual cannot cover all possible
conditions and situations . The operator
must understand that common sense
and caution are factors that cannot
be built into this product but must be
provided by the operator .
Additional safety instructions for the
use of face plates
Make sure the face plate is the correct
size to support the workpiece .
Make sure that the workpiece is
securely attached to the face plate .
Before mounting the workpiece on a
face plate, cut the workpiece as close
as possible to the final shape.
Only use a scraper chisel to turn the
face plate . Cutting chisels can be
pulled out of your hands easily .
Make sure that the wood-turning chisel
cannot interfere with the retaining
screws on the finished dimensions of
the workpiece .
14 GB
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this
product by means of this instruction
manual . Memorise the safety warnings
and follow them to the letter . This will help
to prevent risks and hazards .
Always be alert when using this
product, so that you can recognise and
handle risks early . Fast intervention
can prevent serious injury and damage
to property .
Switch the product off and
disconnect it from the mains if there
are malfunctions . Have the product
checked by a qualified professional
and repaired, if necessary, before you
operate it again .
˜ Residual risks
Even if you are operating this product
in accordance with all the safety
requirements, potential risks of injury and
damage remain . The following dangers
can arise in connection with the structure
and design of this product:
Only use selected timbers without
faults such as:
Knots
–
Transverse cracks
–
Surface cracks
–
Defective wood is prone to splintering
and becomes a risk when working .
Timbers that are not carefully glued
can explode due to the centrifugal
force during machining .
Before clamping: Cut the raw
workpiece into a square shape,
centre it and ensure that it is securely
clamped . Imbalance in the workpiece
leads to the danger of injury .