Replacing The Lamp - Electrolux ENN2800BOW Benutzerinformation

12 www.electrolux.com
Problem
Water flows into the refrig‐
erator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

7.2 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
Possible cause
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
2. Replace the lamp with one of the
Solution
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance.
1
2
1
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.