Scheppach HM216 Original Bedienungsanleitung Seite 34

14. Troubleshooting
Fault Possible cause
Motor does not work
Motor, cable or plug defective, fuses burnt
Voltage too low, coils damaged, capacitor
The motor starts
up slowly and does
burnt
not reach operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
Circuits in the network are overloaded
The motor does not
reach its full power. (lamps, other motors, etc.)
Overloading of the motor, insu昀케cient cool-
Motor overheats eas-
ily.
ing of the motor
Saw cut is rough or Saw blade dull, tooth shape not appropriate
wavy
for the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw
and/or splinters blade not suitable for use
34 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Arrange for inspection of the motor by a special-
ist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re­sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade