Exide MOTION+ PREMIUM SP3 Bedienungsanleitung Seite 3

1 English
1.1 Introduction
In response to growing global environmental concerns and our
commitment to sustainability, we are taking targeted measures to
integrate environmentally friendly practices into all areas of our bu-
siness. We are constantly striving to reduce our paper consump-
tion, which is why we have provided this printed manual in English
only. However, online versions are available in other languages. To
access these, simply scan the QR code.
1.2 Safety
Only an adult trained person should operate this equipment. The input and output voltages
used with this equipment may be high enough to endanger life, so insulated, shrouded
connectors must be fitted. This device is only suitable for industrial use.
Please read this manual completely and convey instructions to all personnel concerned.
Keep the manual in a safe and convenient place.
It is advisable to thoroughly read the information on battery safety supplied with the battery,
prior to charging.
Towards the end of charge, lead acid batteries give off hydrogen gas, which is explosive if
in sufficient concentration, therefore avoid flames and sparks. Appropriate measures must
be taken to ensure adequate ventilation.
Incorrect use of a charger or maladjustment of its controls can damage a battery. The
equipment has been factory set and does not require user adjustment.
This product has been designed, manufactured and certified to be in conformance with Eu-
ropean Union (CE), United Kingdom (UKCA) and Australian (RCM) Safety and EMC Direc-
tives. Testing has ensured that the battery and charger combination conform as a system
for use in Light and Heavy Industrial environments for each respective product variant. The
following notes are for the guidance of the person installing and using the product.
The charger must be isolated from the input supply and the battery, before any panels are
removed.
1.3 Installation
Installation must only be carried out by suitably qualified personnel and in accordance with
current local and national wiring regulations.
Battery leads should not be altered without prior consultation with service personnel.
The charger should be sited in a cool, dry, well-ventilated location away from corrosive fu-
mes and humid atmospheres.
Care must be taken to ensure that the chargers vents are not obstructed and have at least
100 mm of clearance from any surface. Chargers must be positioned so that the exhaust of
one charger is not directly affecting the inlet of another.
The charger is intended for indoor use only. Before installation, check that:
• The charger has not sustained any transit damage.
3/87
English
Multilingual manual