eta Rover 1248 90010 Bedienungsanleitung Seite 52

EN
Routine cleaning (CLASSIC)
Press the F8 button on the remote control. The vacuum cleaner moves gradually and
systematically through the space as it cleans. Cleaning continues until the battery capacity
is exhausted. The vacuum cleaner then automatically searches for a charging station.
Local cleaning (SPOT)
Place the vacuum cleaner where you want to clean (starting point). Press the F3 button on
the remote control. When cleaning, the vacuum cleaner moves in the space according to
the programmed route (spiral). When cleaning is complete, the vacuum cleaner remains
standing at the starting point. This cleaning mode is suitable for cleaning a small soiled area.
Edge mode (EDGE)
This mode is good for cleaning the edges and corners of a room. Press the F6 button on the
remote control. In edge cleaning mode, robot runs along a border (e.g. wall). Under this mode,
the robot will go back to the charging base once cleaning finished. In order for the cleaning
along the walls to proceed properly, remove unwanted objects (e.g. chairs, etc.) from the path of
the vacuum cleaner. This will prevent the vacuum cleaner from getting stuck in one place.
Return to the charging station
In Auto Cleaning, Normal Cleaning and Wall Cleaning modes, the vacuum cleaner features
an automatic return to the charging station when cleaning is complete. You can also send the
device to the charging dock by pressing C2 on the control panel or F4 on the remote control.
After pressing A12 reset button, all parameters set using the ETA SMART
5.5 USING THE MOPING ATTACHMENT
1. Attach the G1 mop to the lower part of the moping
attachment correctly. Soak and wring the mop
before use.
2. Place the mop attachment at the bottom of
the vacuum cleaner.
CAUTION
application will be lost.
EN - 52