Herunterladen Diese Seite drucken

Creality CFS Benutzerhandbuch Seite 8

Vorschau ausblenden Andere Handbücher für CFS:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 47
Loading Filament from the CFS
Important: To avoid filament spool issues, do not use cardboard spools with untreated
or deformed edges, as this can cause the filament to get stuck.
Filament Management Interface Overview:
a) Refresh RFID Button: Reads the RFID tag on the filament.
o If successful, the remaining filament amount and filament color will be
displayed.
o If the reading fails, a "?" will appear, and the filament editing button will
become available.
b) Empty Slot: Indicated by a "/". No filament is assigned to this slot, and editing is
not supported.
c) RFID Filament:
o When RFID is successfully read, the filament data will appear. The eye icon
allows you to view filament information, but editing is not supported for
RFID-enabled filaments.
o To switch to non-RFID filament, click the pre-loading button, wait for the
system to process the RFID, and then click the filament editing button.
d) Ordinary Filament: Non-RFID filaments support full editing within the interface.
e) Unread RFID State: If the RFID cannot be read, a "?" will appear. Click the edit
button to manually input filament information.
f) Humidity Status Indicator:
o Green: Humidity levels are optimal.
o Orange: Humidity is slightly elevated.
o Red: Humidity is too high, indicating the desiccant may need to be
replaced.
Introduction to the Filament Management Interface
o The filament management page is divided into two sections: the spool holder (on
the left) and the CFS unit (on the right).
8

Werbung

loading