Creality CFS Benutzerhandbuch Seite 10

CFS Units to Filament Buffer:
•
o Up to four CFS units (CFS 1, CFS 2, CFS 3, CFS 4) can be connected to the
Filament Buffer.
o Each CFS unit delivers filament to the Filament Buffer via its own PTFE
tube.
o Power supply and data from all four CFS units are routed to the Filament
Buffer for centralized control.
Filament Buffer to Printer:
•
o The Filament Buffer manages the filament flow from all connected CFS
units.
o It then transfers the filament to the printer via a single PTFE tube,
ensuring smooth and continuous feeding.
Safety and Maintenance Instructions
Socket Accessibility: Ensure that the socket-outlet for plug-in equipment is always
easily accessible. This is important to allow quick disconnection in case of an emergency
or servicing needs.
Avoid Water Exposure: Do not use this apparatus near water or in damp
environments. Exposure to water can cause electrical hazards or damage to the device.
Cleaning Guidelines: Clean the apparatus only with a dry, soft cloth. Avoid using water,
cleaning solutions, or abrasive materials that could damage the surface or internal
components.
Approved Accessories: Only use attachments or accessories that are specified or
approved by the manufacturer. Unapproved accessories may result in malfunction,
reduced performance, or safety hazards.
Power Precautions During Storms and Extended Inactivity:
Unplug the apparatus during lightning storms to prevent power surges from
•
causing damage.
If the apparatus will not be used for an extended period, disconnect it from the
•
power source to save energy and protect the device from potential electrical
issues.
When to Seek Servicing:
All servicing must be carried out by qualified service personnel. Do not attempt to
•
repair the apparatus yourself.
Servicing is required if any of the following occur:
•
o The power supply cord or plug is damaged.
o Liquid spills or objects fall into the apparatus.
10