First Use; Switch On-Off; Daily Use - AEG Electrolux A 80380 GT Gebrauchsanleitung

Danger!
Ensure that the freezer is not resting on the power
supply cable.
Do not remove the power supply cable by pulling on its
lead, particularly when the freezer is being pulled out of
its niche.
The power supply cable may only be replaced by a
qualified service personel.
Ensure that the power plug is not squashed or
damaged by the back of the freezer.
There must be adequate ventilation around the
appliance.
Any electrical work required to install this appliance
should be carried out by a qualified electrician.

First use

Before first use, the freezer should be cleaned inside,
see chapter "Care and cleaning".
Plug in the appliance.
Press button (A) to switch the appliance on.
The display will illuminate.
The symbol ( ) will flash on the display and the alarm
will beep, since the temperature inside the freezer is
not yet sufficiently low for food storage.
Press button (E) to switch the alarm off. The symbol
( ) will normally stop flashing after several hours.
Only place food inside the freezer once the symbol
( ) has gone. The temperature of the freezer is set to
reach -18°C, which is the optimal storage temperature
as set in the Eco Mode (

Switch on-off

Switch on the freezer
Press button (A) to switch the appliance on.
The display comes on.
Switch off the freezer
Press button (A) for more than one second until the
countdown "3-2-1" disappears and you hear a
sequence of beeps.
The display goes off.
Warning! Do not place objects on the control panel, as
they might accidentally switch off the freezer.

Daily use

Temperature adjustment
The temperature may be adjusted between -15°C and -
24°C. We suggest setting the freezer tem+G41perature to
-18°C, which guarantees proper freezing and conservation
of frozen food.
Press button (B) several times until the desired
temperature is reached.
The temperature on the display flashes and indicates
the temperature set.
)
Press button (E) to confirm the desired temperature.
You will hear a beep.
The temperature on the display stops flashing again
and indicates the temperature inside the freezer.
The newly adjusted temperature is reached after
several hours. During this time it is normal that the
temperature displayed is different from the temperature
set.
Attention! Differences between the temperature displayed
and the temperature set are normal, especially when:
The temperature setting has recently been adjusted.
The lid has been left open for a long time.
Warm food has been placed in the freezer.
The Super Freeze function is activated.
Super Freeze function
If more than 3-4 kg of fresh food is to be frozen, the freezer
needs to be pre-cooled.
At least 24 hours before placing fresh food in the
freezer, press button (D) several times until the
corresponding symbol (
Press button (E) within
a few seconds to confirm the Super Freeze activation.
The symbol ( ) stops flashing, you will hear a beep
and the animation on the display speeds up.
Place the food in the freezer. After 52 hours this
function will automatically stop and the freezer will
return to normal storage temperature. This function
can be de-activated at any time by pressing button (D)
until the corresponding symbol (
display again and then by pressing button (E) to
confirm the de-activation.
Drinks Chill function
Use this function as a safety warning when placing bottles
in the freezer, as they may burst when forgotten in the
appliance.
Press button (D) several times until the corresponding
symbol ( ) flashes on the display.
Press button (E) within a few seconds to confirm the
Drinks Chill activation. The symbol (
and you will hear a beep.
Press button (B) several times or continuously to set
the desired number of minutes (from 1 to 90 minutes).
Place the drinks in the freezer.
At the end of the set time, the alarm will beep and the
symbol ( ) and the time will flash on the display.
Press button (E) to switch the alarm off.
Remove the drinks from the freezer. It is possible to de-
activate this function at any time by pressing button (D)
until the corresponding symbol (
display again and then by pressing button (E) to
confirm the de-activation.
Eco Mode function
Use this function to automatically set the freezer
temperature to its best level (- 18°C), which guarantees
proper conservation of frozen food at the lowest energy
consumption.
EN
) flashes on the display.
) flashes on the
) stops flashing
) flashes on the
11