cecotec FAST&FURIOUS 5020 FORCE Bedienungsanleitung Seite 32

ENGLISH
Insert the power plug into the wall socket. The light indicator will turn on.
Once the indicator light turns off, the iron is ready to be used.
Filling the water tank
Unplug the iron before filling the water tank.
Hold the steam iron in horizontal position.
Slowly pour water through the water filling opening. Do not exceed the Max. mark on the water
tank in order to avoid water from spilling.
Close the filling opening while operating the iron.
Empty the water tank after each use.
Note: Do not use chemically descaled or perfumed water.
Spraying
The spraying function can be used at any temperature during steam ironing or dry ironing,
provided that the water tank is full.
Steam ironing
While the appliance is unplugged, fill the iron with water.
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and connect
it to the power supply.
Set the temperature knob to the "••" or "•••" position.
Set the steam knob to the desired position.
When finished, turn the temperature knob anticlockwise to the minimum position and unplug
the appliance from the power supply.
Warning: Do not come into contact with the ejected steam.
Dry ironing
The steam iron can operate with or without water in the water tank. In case the iron is operated
in its dry mode, make sure the water tank is empty.
Turn the steam knob to "0" position.
Warning: If the iron has been used during more than 10 minutes and it is hot, do not pour more
water inside it until the appliance has cooled down.
Steam burst
The steam-burst function generates additional steam in order to remove stubborn creases
and can be activated just by pressing the steam-burst button.
32 FAST&FURIOUS 5020 FORCE