Table 1-1. System Messages (continued)
Message
TPM configuration
operation honored.
TPM Failure
TPM operation is
pending. Press I
to Ignore or M to
Modify to allow
this change and
reset the system.
WARNING: Modifying
could prevent
security.
Warning: Following
faulty DIMMs
are disabled:
DIMM n
n
1
2
Total memory size
is reduced.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
Warning! No micro
code update loaded
for processor n
Causes
System now resets.
A Trusted Platform Module
(TPM) function has failed.
Configuration change
has been requested.
Faulty or improperly
seated memory module(s).
DIMMs are disabled in
pairs, as indicated by the
n
and n
. Check both
1
2
DIMMs for a possible fault.
A fatal system error
occurred and caused the
system to restart.
Micro code update failed.
Corrective Actions
Information only.
See "Getting Help" in the
Hardware Owner's Manual.
Press I to continue system
boot. Press M to modify the
TPM setting and restart.
See "Troubleshooting
System Memory" in the
Hardware Owner's Manual.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in See
"Troubleshooting Your
System" in the Hardware
Owner's Manual. for any
faulty components specified
in the SEL.
Update the BIOS firmware.
See "Getting Help" in the
Hardware Owner's Manual.
Information Update
13