Hilti PP 11 Bedienungsanleitung Seite 24

Parameter selection
&
Automatic centering
&
Laser beam up / down
(
Value entry
(
SET button
)
ON / OFF button
+
7.2 Symbols in the display 4
Plumb spot indicator.
@
Alignment indicator
;
Battery status indicator
=
Self-leveling indicator
%
Inclination indicator
&
Percentage
(
Lock symbol
)
Electronic bubble level
+
Laser mode display
§
7.3 Warnings displayed 5
Battery status warning
@
Leveling warning
;
Transverse inclination warn-
ing
=
7.4 Switching the tool on
Press the ON / OFF button.
NOTE
The PP 10/11 is capable of leveling itself within a range
of +/- 10%. The tool levels itself automatically when set
up within this range. The LED begins to blink when the
inclination of the tool is more than +/- 10% from the
set inclination. The tool should then be rotated in the
direction indicated by the arrow.
7.5 Setting the inclination 6
Inclination can be set either manually or automatically.
Inclination can be set within the -15% to +40% range (for
inclinations over 10%, an accessory or other aid is used
to provide initial inclination of the laser tool).
7.5.1 Automatic entry of inclination 6
1. Switch the tool on by pressing the ON / OFF button.
2. Press the SET button. The set value is displayed and
the ± indicator blinks.
3. Press the laser beam UP or DOWN button to change
the sign.
Used to select the parameters to be set.
The laser beam centers itself automatically when both direction control
buttons are pressed at the same time.
Moves the laser beam up or down.
Positive or negative values may be entered. When both buttons are
pressed at the same time, inclination is set automatically to 00.000%.
This button is used to confirm the selected parameters.
This button is used to switch the tool on or off.
Shows that the plumb spot is active.
Indicates laser beam alignment.
Remaining battery capacity is shown in 3 levels.
Blinks while the laser is leveling itself. The display subsequently changes
to the laser mode set.
Shows the selected inclination.
Shows the unit of measurement selected (percentage or per thousand).
The values entered cannot be changed.
Shows whether the tool is leveled correctly.
The laser modes "blinking", "normal" and "high-power" (PP11) are
shown.
Operation is no longer possible. Replace / recharge the battery or con-
nect an external power source.
The laser is tilted beyond its self-leveling range. Tilt the laser tool in the
direction of the arrow shown in the display.
The laser tool has been rotated beyond its self-leveling range. Rotate the
laser tool in the direction of the arrow shown in the display.
4. Press the right-hand direction control button in order
to reach the correct position (the left direction control
button can be used to move back).
5. Press the laser beam UP or DOWN button to change
the value.
6. Press the right-hand direction control button to
move to the next position.
7. Press the laser beam UP or DOWN button to change
the value. Repeat the steps described above to
change other numerical values.
8. Press the SET button when the value entered is
correct.
The laser beam then begins to move to the specified
setting.
7.5.2 Manual entry of inclination
NOTE
Inclination can also be set directly by moving the laser
beam. Check that the locking function has not been
activated.
en
19