OHAUS Frontier 5000-Serie Bedienungsanleitung Seite 25

Frontier™ 5000 Series Multi
A-1
3.9.3 Leaving program mode
To leave the program mode just press the key "Prog/Setup" (9) (see Figure 24). Then inside the display
"Time/Prog" (A-1) the word "programm" (M10) appears. Set the display to "programm--" (M10) with the touch
wheel (1).
3.10 Starting and Stopping the Centrifuge
3.10.1 Starting the centrifuge
You can start the centrifuge either with the "Start" key (8) (see Figure 25) or the "Quick Spin" key (6). By the
"Start" key (8) you can start stored runs or runs with manually pre-selected parameters.
When the respective pre-selected running time has ended the centrifuge will stop automatically. By the "Quick
Spin" key (6) you can start runs, which will last just a few seconds.
By pressing the "Quick Spin" key (6) the centrifuge accelerates up to the pre-selected revolution.
In the display "Time/Prog" (A-3) the passed running time is indicated from the date of pressing the "Quick Spin"
key (6).
By releasing the "Quick Spin" key (6) the centrifuge stops and the running time is indicated until the opening of the
lid.
M3 M4
Figure. 24
Figure 25
A-3
M10
A-3
EN-20
9
1
8
6