What To Do If; Technical Data - IKEA FRAMTID HGA1K Bedienungsanleitung

ENGLISH
Stainless steel elements wash with water, and
then dry with a soft cloth.
This model is equipped with electrical ignition,
it is obtained through ceramic "candle" and
electrode.
Keep them well clean to avoid difficult light-
ning.

What to do if...

Problem
There is no spark when light-
ing the gas
The flame is blowing out im-
mediately after lightning
The gas ring burns unevenly
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact your
dealer or the After Sales Service.

Technical data

Hob dimensions
built in height
Class Appliance: 3
Appliance Category: II2H3B/P (AT) /
II2E3B/P (DE)
Appliance gas supply:
Natural gas G20 (2H) 20mbar (AT)
There is no electrical supply
Burner cap and Crown are
placed uneven
Thermocouple is not heated
enough
Burner crown is blocked with
food residues
width
depth
Periodically ask your local Service Centre
to check the conditions of the gas supply
pipe and the pressure adjuster, if it is fitted (this
service is not free of charge).
After cleaning, be sure to wipe dry with a soft
cloth.
Possible cause
If you operated the appliance wrongly, or
the installation was not carried out by a
registered engineer, the visit from the customer
service technician or dealer may not take
place free of charge, even during the warranty
period.
Natural gas G20 (2E) 20 mbar (DE)
This appliance is designed for use with natural
gas but can be converted for use with other
gas type according to table below.
Remedy
Check that the unit is plugged
in and the electrical supply is
switched on.
Check the house electric in-
stallation fuse.
Check the burner cap and
crown have been replaced
correctly, e.g. after cleaning.
After lightning the flame, keep
the knob pushed for about 5
sec.
Check the main injector is not
blocked and the burner crown
is clear of food particles.
290 mm
510 mm
30 mm
7