Werbung
Use
__________________________________
First Use
In rare cases the thin tension ropes can be caught witihin each other during transporta-
tion. In this case we recommend extending the screen in small 10 cm steps when you
extend it for the first time, so you can immediately see and remove tangles in the ropes.
Wall panel
Press the upper button to
retract the screen, the
bottom button to extend
the screen. The „Stop"
button stops the screen at
any desired position.
Remote control
Press the upper button to retract
the screen and the bottom but-
ton to extend the screen. The
„Stop" button stops the screen at
any desired position.
Permanently set extension length
A - via remote control
1. First retract the screen completely.
2. Now extend the screen by pressing the
„Down" button.
3. When the screen has reached the desired
position press the buttons „Stop" and
„Down" at the same time. You will hear a
double beep. Now, after you retract the
screen completely and once more extend
the screen, it will stop permanently in this
position.
IMPORTANT: The remote control does
not save the position of your screen, but sa-
ves the time that was required to reach the
desired extension length. Therefore, you
must not interrupt the extension of the
24
screen by pressing the „Stop" button and
then resuming extension.
IMPORTANT: If you frequently extend and
retract the screen, the motor will switch off
due to overheating and will only work again
when it has cooled to operating tempera-
ture.
4. Clearing the programming:
Press the „Up" and „Down" buttons at
exactly the same time to cancel the pro-
grammed extension length. You will hear a
double tone.
Permanently set extension length
B - via adjusting screws
If setting the extension length by remote
control is not accurate enough for you, you
can adjust the extension length with the ad-
justing screws.
On the right side of the canvas there are two
screws on the tube that holds the canvas.
You can reach the screws through the ope-
ning where the screen extends from the
housing. The red screw controls the exten-
sion stop point. Turning clockwise extends
the screen further. The white screw controls
the retraction stop point. Turning clockwise
will retract the screen further.
IMPORTANT: Since the adjustment of
these screws can easily cause damage to the
screen, we do not recommend making ad-
justments to these screws. Damage to the
Werbung
