General Information - Scholtes HP 95 Gebrauchs- Und Installationsanleitungen

GENERAL INFORMATION

1. Before installing and/or using this hood, please read the instructions
carefully and thoroughly.
2. Before you install the hood, make sure the voltage (V) and frequency
(Hz) indicated on the serial and technical data plate located inside
the appliance correspond with the voltage and frequency available in
the place of installation.
3. After having removed the packaging, check that the appliance is intact. If
in doubt, do not use the appliance and contact professionally qualified
personnel.
4. All installation and adjustment operations should be carried out by a
qualified technician in accordance with the regulations in force. Specific
indications are given in the section intended for the installer.
5. Clean the hood according to the manufacturer's instructions, especially
for the deposits formed on the dirty surfaces to avoid any risks of fire.
6. Ensure the burners are always covered so as not to cause the hood filter
to overheat.
7. When frying food, never leave the pan unattended: the oil inside the pan
could overheat and catch fire. If the pan contains oil which has already
been used to fry, the risk of spontaneous ignition is even greater.
8. It is strictly forbidden to flambé food beneath the cooker hood.
9. The air collected should not be conveyed in a duct used for the discharge
of exhaust fumes from appliances that run on energy sources other than
electricity.
10.Suitable ventilation of the room must be provided when the hood and
appliances that run on energy sources other than electricity are used at
the same time.
11.If the hood is used in the outdoor venting mode, check the condition of the
exhaust duct should the latter have been left unused for an extended period
of time.
12.Remember to pay attention to the local norms in force and to the regulations
from the competent authorities on the subject of air exhaust when the
hood is operating in the outdoor venting mode.
13.All advice given on this matter must be followed scrupulously in order to
avoid possible fires.
14.FAILURE TO OBSERVE THE ABOVE-MENTIONED INDICATIONS AS TO
THE INSTALLATION, MAINTENANCE AND SUITTABLE USE OF THE
HOOD RELIEVES THE MANUFACTURER OF ALL LIABILITY.
I
NSTALLATION
The accessories required for the installation of the hood can be found inside
the latter.
The hood is convertible and can therefore be installed in either the OUTDOOR
VENTING or the AIR RECIRCULATION mode. If the hood is used in the
OUTDOOR VENTING mode, connect opening N (120 mm diameter) (fig. 1) to
an exhaust duct connected directly to the outside and which is 150 cm2
minimum in cross-section. The lowest part of the hood should be at least 70
cm from the hob.
IN NO CASE WHATSOEVER SHOULD THE HOOD BE CONNECTED TO
EXHAUST DUCTS FROM OTHER APPLIANCES THAT RUN ON ENERGY
SOURCES OTHER THAN ELECTRICITY (water heaters - boilers - stoves -
etc.). The appliance must not be placed above stoves with a top radiant plate.
6
R
N
Fig. 1