Configuring The Sliding Rail Assemblies - Dell Precision R5400 Installations Anleitung

Configuring the Sliding Rail Assemblies

The sliding rail assembly has a rotating mounting bracket at each end of the rail. The position of the
bracket determines whether the rail assembly is used as a RapidRail or a VersaRail. The RapidRail side of
the bracket has a hook and a latch that secure it to the vertical rail. The VersaRail side of the bracket has
three holes and uses screws to attach it to the vertical rail.
NOTE:
The rack kit ships with the slide assemblies in the RapidRails configuration.
To change from one type of rail assembly to the other type of rail assembly:
1 Lift the blue lever on the rotating mounting bracket (see Figure 1-4).
2 Rotate the bracket and slide it up off of the two shoulder standoffs.
3 Continue to rotate the bracket 180 degrees until you can set the notches back over the shoulder
standoffs.
4 Rotate the bracket in the opposite direction until the bracket clicks into place.
Figure 1-4. Changing the Position of the Rotating Mounting Bracket
1
5
1 mounting-bracket flange
(RapidRails version shown)
4 shoulder standoffs (2)
2
3
4
2 rotating bracket
5 notches (2)
3 release lever
Rack Installation Guide
11