Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3. Tuningmode
Activating the tuning mode:
1.
Switch on e-bike → [Display stays at 0.0
2.
Switch off the e-bike after it has started up completely (for Brose Motor deep sleep mode: hold down
the power button for at least 3 seconds or briefly remove the battery), wait at least 5 seconds.
3.
Switch on e-bike → [Display shows 10.0
value), tuningmode]
Speed representation: The speed actually driven remains readable in normal tuning mode with the speed limit
not reduced and in stealth mode even with a reduced speed limit. Up to 20
displayed via the second digit and the decimal place. Speed display example: 23.5
Automatic route compensation: In order to compensate for the difference between the distance actually
covered and the distance displayed, the maximum speed driven is displayed after about one minute of standstill
until the distance has been covered. As soon as the difference has been compensated, the display drops to 0.0
and the e-bike switches itself off after a while. If the e-bike is switched off beforehand, the sIMPLEk saves the
difference and catches up later. As a result, the maximum speed and the distance traveled/total distance are
correctly displayed.
BROSE Note: When changing the operating modes, it is necessary to put the e-bike into deep sleep mode when
switching off. This is achieved by holding down the power button on the control unit or on the battery for at least 3
seconds. With some firmware versions, switching to deep sleep mode can only be achieved by briefly removing the
battery. This also applies to the shutdown processes during calibration.
, 1:1 mode]
with correct calibration (otherwise a different constant
it is displayed 1 to 1, above 20
→ 35
it is
Werbung
