Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Operation
3.1. Calibrationmode
The calibration must be carried out once. It must be carried out at a standstill and with the battery pack inserted. It
is called up automatically on the first start. If the e-bike does not have a speedometer, calibration is not required
(see note on e-bikes without display). The calibration consists of two sections. First a rough calibration, then a fine
one. In the first section of the calibration, an increasing speed is output on the speedometer. Switch off the e-bike
as precisely as possible at 10.0
out. A speed is output on the speedometer, which gradually approaches 10.0
briefly drops towards 0.0
the e-bike again and wait at least 5 seconds.
Carrying out calibration at first start-up:
1.
Switch on the e-bike → [Display shows slowly increasing speed, calibration level 1]
2.
Switch off e-bike at approx. 10.0
seconds or briefly remove the battery)
3.
Switch on the e-bike → [Display shows slowly increasing speed and keeps
dropping towards 0
4.
Switch off e-bike at exactly 10.0
seconds or briefly remove the battery)
Start the calibration again manually:
1.
Switch on e-bike → [Display stays at 0.0
2.
Switch off the e-bike after it has booted up completely (for Brose Motor deep sleep mode: hold down
the power button for at least 3 seconds or briefly remove the battery), wait 5 seconds
3.
Switch on e-bike → [Display shows 10.0
tuningmode]
4.
Switch off the e-bike after 10.0
mode: hold down the power button for at least 3 seconds or briefly remove the battery), wait 5 seconds
5.
Switch on the e-bike → [CalibraPon level 1]
and wait at least 5 seconds. After switching on again, the fine calibration is carried
. As soon as 10.0
is displayed for the first time (it can take several minutes), switch off
(for Brose Motor deep sleep mode: hold down the power button for at least 3
, wait 5 seconds
, calibration level 2]
(for Brose Motor deep sleep mode: hold down the power button for at least 3
, wait 5 seconds
or another constant value is displayed (for Brose Motor deep sleep
, 1:1 mode]
with correct calibration (otherwise a different constant value),
in small steps and, in the meantime,
Werbung
