Technical Data; Proper Use - EINHELL QH 1800 Betriebsanleitung

Anleitung QH 1800_SPK1:Anleitung QHT 1500_
GB
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Quartz heating elements
2. Heat setting display
3. Pull switch

3. Technical data:

Rated voltage:
Output: 1800 W (600 W / 1200 W / 1800 W)
Protection type:

4. Proper use

The equipment is designed for use in areas in which
immediate heat is required quickly (for example
bathrooms, hobby rooms, etc.). The equipment is not
to be used for heating rooms, in vehicles or outdoors.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Mounting on the wall (Fig. 2-3)
Read the safety instructions listed in section 1.
Important! Never switch on the equipment in a
vertical or angled position (see Fig. 5). This may
cause the equipment to malfunction.
8
25.06.2010
Important! Make sure that there are no electric
cables or other installations (for example water
pipes) near the drill holes. Make sure that the
appliance is securely and horizontally fitted to the
wall.
Use only suitable fastening material on a wall
capable of bearing the load. The supplied dowels
and screws are suitable for the following: Concrete,
natural stone with a dense structure, solid brick, solid
limestone bricks, solid lightweight concrete bricks
and aerated concrete.
To mount on a wall, please use the supplied wall
bracket.
Drill the three holes (1) such that the legs (2) of
the wall bracket are vertical.
Slide the plastic housing of the heater onto the
wall bracket from the top and as far as the stop. In
230 V ~ 50 Hz
doing so, the legs (2) of the wall bracket are
pushed into the slots (3) in the plastic housing.
IP24 Screw the wall bracket to the heater using the
short screw (4) supplied.
6. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate.
Read the safety instructions listed in section 1.
The quartz radiant heater warms objects or persons
at which it is pointed but does not directly heat the
room air in the process. The heat output is set by a
switch with pull cord. The selected setting is
displayed.
6.1 Setting the heat output (Fig. 1):
The heat output is set by pulling the cord of the pull
switch (3) once or repeatedly. The selected heat
output can be read off the display (2). If the
maximum heat output is selected and the pull switch
is activated once more, the appliance shuts down.
6.2 Display of heat settings
No heat output = Display indicates "0", no heating
elements activated
Minimum heat output = Display indicates "1", one
heating element activated
Medium heat output = Display indicates "2", two
heating elements activated
11:02 Uhr Seite 8