Warnings - Testboy Tv 465 Bedienungsanleitung

®
Testboy TV 465

Warnings

o
In order to reach a high level of operator safety while carrying out various measurements
using the instrument, as well as to keep the test equipment undamaged, it is necessary to
consider the following general warnings:

Warning on the instrument means »Read the Instruction manual with
special care to safety operation«. The symbol requires an action!

Read this instruction manual carefully, otherwise use of the instrument may be
dangerous for the operator, for the instrument or for the equipment under test!

If the test equipment is used in manner not specified in this instruction manual
the protection provided by the equipment may be impaired!

Do not use the instrument and accessories if any damage is noticed!

Appliances MUST be fully disconnected from the mains supply before it is
connected to the TV 465 in order to perform a PAT test.

Do not touch any test leads/terminals while the appliance is connected to the
TV 465.

The Instrument should not to be used for measurements while charging.

Consider all generally known precautions in order to avoid risk of electric
shock while dealing with hazardous voltages!

Use only standard or optional test accessories, supplied by your distributor!

Instrument servicing and adjustment is only allowed to be carried out by
competent authorized personnel!

Hazardous voltages can exist inside the instrument. Disconnect all test leads,
remove the power supply cable and switch off the instrument before opening
the battery compartment.

Instrument contains rechargeable NiCd or NiMh battery cells. The cells should
only be replaced with the same type as defined on the battery placement label
or in this manual. Do not use standard alkaline battery cells while power supply
adapter is connected, otherwise they may explode!

If a test code with an earth bond test current higher than 200 mA is selected
(manually, with barcode reader or with RFID reader/writer) the TV 465
instrument will automatically perform the Earth continuity test with a 200 mA
test current. Other test parameters remain unchanged. The operator must be
competent to decide if performing the test with a 200 mA current is acceptable!

The Substitute leakage current / Substitute leakage - P tests can be carried out
as an alternative for the Leakage and Touch leakage tests if there are no mains
supply dependent switches inside the equipment. The operator must be
competent to decide if performing the Substitute leakage current test is
applicable!

If a test code with a Leakage current is selected (manually, with barcode reader
or with RFID reader/writer) the TV 465 instrument will automatically perform a
Substitute leakage test. Other test parameters remain unchanged. The operator
must be competent to decide if performing the Substitute leakage test is
acceptable!

If a test code with a Touch leakage current is selected (manually, with barcode
reader or with RFID reader/writer) the TV 465 instrument will automatically
perform a Substitute leakage - P test. Other test parameters remain unchanged.
The operator must be competent to decide if performing the Substitute leakage
- P test is acceptable!
75
General description