Bresser Translucidus NV Bedienungsanleitung Seite 12

9 Battery level indicator
1.
2.
NOTICE! The symbol for the battery level indicator is only
displayed when the batteries are empty. If the battery level
is sufficient, the icon will not be displayed.
10 Automatic time setting
After power supply has been established, the unit automat-
ically searches for the radio signal. It takes approximately 3
to 8 minutes for this process to be completed.
If the radio signal is correctly received, the time is set auto-
matically and the reception symbol is displayed.
If the radio clock signal is not received, press the UP button
for approx. 3 seconds to initiate signal reception.
If still no radio signal is received, the time must be set
manually.
11 Manual time setting
1.
2.
3.
12 / 40
When the level of the batteries in the base station or in
the wireless sensor reaches a critical level, the battery
level symbol appears in the appropriate area on the
display.
When replacing a set of batteries, always remove the
batteries from the other part of the device and reinsert
the batteries in the order intended (see chapter "Estab-
lishing the power supply"). Replace the batteries to be
replaced in the corresponding part of the device with a
completely new set with full capacity. This ensures that
the connection between the devices is re-established
correctly.
Press the [SET] button for approx. 3 seconds to enter
the time setting mode.
Digits to be set are flashing.
Press [UP] or [DOWN] button to change the value.